Quality
Control
(413) 283-4630
sales@innovativeplasticsystems.com
Innovative Plastic Systems, Inc. | Mailing Address: P.O. Box 92, Monson, MA 01057
Plant Address: 15 Second Street, Palmer, MA 01009
(Located in the village of Bondsville, MA, within the Palmer Industrial Park)
Phone: 413.283.4630 | Email: sales@innovativeplasticsystems.com
Plant Address: 15 Second Street, Palmer, MA 01009
(Located in the village of Bondsville, MA, within the Palmer Industrial Park)
Phone: 413.283.4630 | Email: sales@innovativeplasticsystems.com
The IPS 3-step QC process guarantees that only the highest quality plastic products are delivered to our customers. We inspect EVERY plastic molded part multiple times to ensure that your expectations are met with minimal risk of defects.
At IPS we understand there are a wide range of industry standards, which is why we design to meet or exceed the all special standards as requested by our customers.
Step 1: Machine Inspection
Parts are initially inspected directly out of our molding machine. Our technicians are trained to identify and rectify the following defects:
At IPS we understand there are a wide range of industry standards, which is why we design to meet or exceed the all special standards as requested by our customers.
Step 1: Machine Inspection
Parts are initially inspected directly out of our molding machine. Our technicians are trained to identify and rectify the following defects:
•
Sink marks that form when the outer plastic shell hardens before the internal plastic has had an opportunity to cool;
•
Short shots caused when there is an inadequate amount of plastic material to fill the mold;
•
Burn marks caused by trapped compressed air during the molding process;
•
Flash marks, which is the excess plastic that extends from the end of the molded part
Step 2: Finishing Station Inspection
Parts at the finishing station are inspected for consistent finishes and textures prior to screen or pad printing.
Step 3: Quality Control Department Inspection
Finished parts undergo one final inspection to ensure tolerances are met for every part.
Digital calipers measure for part accuracy to within =/-.005
Contact IPS for more information about our Quality Control department or procedures. (413) 283-4630.
Parts at the finishing station are inspected for consistent finishes and textures prior to screen or pad printing.
Step 3: Quality Control Department Inspection
Finished parts undergo one final inspection to ensure tolerances are met for every part.
Digital calipers measure for part accuracy to within =/-.005
Contact IPS for more information about our Quality Control department or procedures. (413) 283-4630.